Snom HD100 - Configure System Pages

SIP Phone Configuration Guide
- 10 -
System status - HM201
Software version: 2.22.6.0 or later
- image pending till product is available
Handset status - HD101, HD351W, HM201 only
- image pending till product is available
The handset status page shows the name and the registration status of all the registered cordless
handsets. The page lists the maximum of four handsets, even if fewer handsets are registered. If you
have not given the handsets unique names, their default names of HANDSET will appear.
3.1.4 Step 4: Configure Web Portal Pages
3.1.5 Step 5: Reboot Phone System
A phone system reboot, after changing configuration of the following settings, is required in order to
apply the new settings:
• Network Configuration
• Network Security
• Static IP Mapping
• DECT
• Inter-Op Configuration
After saving the settings, click Reboot to perform phone system reboot.
3.2 Configure System Pages
3.2.1 SIP Account Management
On the SIP Account Management page, you can configure each account you have ordered from your
service provider or configured in your SIP-PBX. The SIP Account settings are also available as
parameters in the configuration file. See Section 6.6.1 SIP Account Settings ("sip_account" Module).