Snom HD100 - Music on Hold Settings; Session Timer; Jitter Buffer

SIP Phone Configuration Guide
- 18 -
Setting
Description
Enable STUN
Enables or disables STUN (Simple Traversal of UDP through NATs) for
account 1. The Enable STUN setting allows the HD10X to identify its
publicly addressable information behind a NAT via communicating with a
STUN server.
Server Address
Enter the STUN server IP address or domain name.
Port
Enter the STUN server port.
Enable STUN Keep-
Alive
Enable or disables UDP keep-alive. Keep-alive packets are used to maintain
connections established through NAT.
Keep-Alive Interval (sec)
Enter the interval (in seconds) for sending UDP keep-alive.
3.2.1.14 Music on Hold Settings
Music On Hold
Enable Local MoH
Setting
Description
Enable Local MoH
Enables or disables a hold-reminder tone that the user hears when a far-
end caller puts the call on hold.
3.2.1.15 Session Timer
Session Timer
Enable Session Timer
Minimum Value (secs)
90
Maximum Value (secs):
1800
Setting
Description
Enable Session Timer
Enter the lower limit of the Real-time Transport Protocol (RTP) port range. RTP
ports specify the minimum and maximum port values that the phone will use
for RTP packets.
Minimum Value (sec)
Set the session timer minimum value (in seconds) for account 1.
Maximum Value (sec)
Set the session timer maximum value (in seconds) for account 1.
3.2.1.16 Jitter Buffer
Jitter Buffer
Fixed
Fixed Delay (ms):
70
Adaptive
3600
Normal Delay (ms):
80
Minimum Delay (ms):
60
Maximum Delay (ms):
240
✓ ✓