1-1. DSR-2000
38
Chapter 2 Setting/Displaying Time Data and Text Information
Chapter 2 Setting/Displaying Time Data and Text Information
Display
Block A Block B
Operation mode
STANDBY OFF Standby off mode
STOP Stop mode
F.FWD Fast forward mode
REW Rewind mode
PREROLL Preroll mode
PLAY Playback mode (servo unlocked)
PLAY Playback mode (servo locked)LOCK
PLAY Deviation from normal
speed (%)
Capstan override mode
REC Record mode (servo unlocked)
REC LOCK Record mode (servo locked)
EDIT Edit mode (servo unlocked)
EDIT LOCK Edit mode (servo locked)
JOG STILL A still picture in jog mode
JOG FWD Jog mode in forward direction
JOG REV Jog mode in reverse direction
SHUTTLE (Speed) Shuttle mode
VAR (Speed) Variable mode
AUTO EDIT Automatic editing mode
PREVIEW Preview mode
REVIEW
Review mode
DMC (Speed)
a)
DMC playback speed
D-PREV (Speed)
a)
DMC editing preview mode
D-EDIT (Speed)
a)
DMC editing mode
DMC-SPD (Speed) DMC initial speed setting
a) Initial speed settings or stored speed settings
CASSETTE OUT
Cassette is not loaded
TAPE UNTHREAD Tape has not been threaded
Displaying Time Data and Unit's Operating Status−Superimposing Text
Information
Chapter 2 Setting/Displaying Time Data and Text Information
Chapter 2 Setting/Displaying Time Data and Text Information
39
Setting Time Code and User Bits
Setting an initial time code value
Set the buttons and switches as shown below.
Button/switch settings
To set an initial time code value, use the following procedure.
REMOTE button
CHARACTER switch
FREE RUN/REC RUN switch
INT/EXT−PRESET/REGEN switch
Buttons/switches
Settings
REMOTE button
Off
CHARACTER switch ON
INT/EXT−PRESET/REGEN switch INT−PRESET
FREE RUN/REC RUN switch
As required
DF/NDF switch As required
RESET button
To Next Page
