1-1. DSR-2000
Chapter 3 Recording and Playback
64
Chapter 3 Recording and Playback
6
Press the SET button.
The recording tape and source tape are both automatically wound back
to the beginning, and dubbing starts. At the same time, the screen
changes as follows.
To end the dubbing operation while it is in progress
Press the STOP button.
The dubbing operation stops and a message asking whether to copy the
contents of the cassette memory appears.
For more information about this, see the section
“If you end dubbing while it
is in progress” (page 65).
When dubbing is completed
1 A message “COMPLETED” appears on the monitor.
2 The source tape and recording tape are both automatically rewound
to the beginning, and the cassettes ejected.
3 The unit returns to the state in step 4.
7
To continue by dubbing another tape, repeat steps 5 and 6.
8
To end the dubbing operation and exit from the menu, press the
MENU button.
Chapter 3 Recording and Playback
Chapter 3 Recording and Playback
65
If the cassette memory of the recording tape is not large
enough
When you insert the recording tape and source tape in this unit and the
player, respectively, with A/V/TC/CM selected as the items for dubbing,
their cassette memory contents are checked automatically. If, as a result,
the cassette memory capacity of the recording tape is found inadequate, the
following message appears.
If this message appears, replace the recording tape by a tape with a larger
cassette memory capacity.
If you end dubbing while it is in progress
If you end dubbing while it is in progress with A/V/TC/CM selected as the
items for dubbing, the following message appears.
To copy the contents of the cassette memory, press the SET button.
If you do not wish to copy the contents of the cassette memory, press the
RESET button. If you press the RESET button, however, the contents of
the cassette memory may not agree with the material recorded on the tape.
To Next Page
