1-32
DSR-2000/2000P
1-1. DSR-2000
Chapter 3 Recording and Playback
62
Chapter 3 Recording and Playback
2
Using the search dial, select AUTO FUNCTION, then press the SET
button.
3
Using the search dial in jog mode, select either SDTI DUBBING or
i.LINK DUBBING, then press the SET button.
The screen changes as follows, allowing you to select a desired group
of items for dubbing.
(In explaining the subsequent operating procedure, illustrations of
screens shown when performing SDTI dubbing are used. You can
follow the same operating procedure also when performing i.LINK
dubbing.)
• A/V: Audio and video
• A/V/TC: Audio, video and timecode
• A/V/TC/CM: Audio, video, timecode, and cassette memory
(ClipLink log data)
SYSTEM MENU
SETUP MENU
AUTO FUNCTION
HOURS METER
AUTO FUNCTION MENU
SDTI DUBBING
A/V
A/V/TC
A/V/TC/CM
Digitally Dubbing Signals in DVCAM Format
(Optional DSBK-190 Required
When Using i.LINK Interface)
AUTO FUNCTION MENU
SDTI DUBBING
i.LINK DUBBING
Chapter 3 Recording and Playback
Chapter 3 Recording and Playback
63
4
Using the search dial, select a desired group of items for dubbing, then
press the SET button.
The menu screen changes as follows.
(Example: The screen displayed when A/V/TC/CM is selected.)
5
Insert the source tape in the player and the recording tape in this unit.
A message to make sure dubbing may be started appears.
If the cassette memory capacity is not sufficient
A message urging you to replace the recording tape by a tape with a
larger cassette memory capacity appears.
For more information about this, see the section
“If the cassette memory of
the recording tape is not large enough
” (page 65).
To cancel the dubbing operation
Press the MENU button.
SDTI DUBBING
(A/V/TC/CM)
INSERT RECORD TAPE IN
THIS VTR AND SOURCE
TAPE IN THE PLAYER VTR.
ABORT:MENU KEY
SDTI DUBBING
(A/V/TC/CM)
START SDTI DUBBING?
START:SET KEY
ABORT:MENU KEY
To Next Page
