1-1. DSR-2000
Chapter 5 ClipLink Operation
Chapter 5 ClipLink Operation
97
Chapter
5
ClipLink Operation
Overview of ClipLink Operation
The ClipLink function provides the following.
• Displaying ClipLink log data
• Cueing up to Mark IN/OUT points and cue points
• Rewriting ClipLink log data (reel numbers, Mark IN/
OUT points, and OK/NG status only)
• Creating additional ClipLink log data and deleting
ClipLink log data (Mark IN/OUT points only)
• Automatically creating new ClipLink log data (Mark
IN/OUT points only)
When Mark IN/OUT points are created, the scene
number and take number for them are fixed at 000 and
00, respectively.
The above operations other than automatic creation of
new ClipLink log data require the ClipLink log data
list display.
Notes
• For a tape on which index pictures are already
recorded, you cannot change any ClipLink log data
other than the reel numbers and OK/NG status.
(When index pictures are recorded on a tape, the
ClipLink log data list for the tape shows an IP
indication.)
• You cannot carry out ClipLink operation such as
“Continue” on the DSR-1/1P or DSR-300/300P/
500WS/500WSP for a tape whose ClipLink log data
has been modified on this unit.
For an overview of the ClipLink function, see the appendix
“
ClipLink Guide” (page 147).
To Next Page
