Sony KDF-E50A10 - Page 13

– 12 –
KDF-E42A10/E50A10
K RM-YD003 RM-YD003
3. Blinking count display ofPOWER/STANDBY indicator
-One blink is not used for self-diagnosis.
-Example
Diagnosis ite
m
LEDblinks
Lamp cove
r
3 times
Fan 4 times
LEDON:0.3sec
LEDOFF : 0.3sec
-Release of POWER/STANDBY indicator blinking
The POWER/STANDBY indicatorblinking display is released by removing the plug fro
m
the power or leaving for 2 minutes.
4. Self-diagnosis screen displays
-Incases of malfunctions where it is not possible to determine the symptom such as when
the power goes off occasionally or when the screen disappears occasionally, there is a
screen display on whether the malfunction occurred or not in the past (and whether the
detection circuit operated or not) in order to allow confirmation.
<Screen Display Method>
-Quickly press the remote command button in the following order from the standby state.
ChannelVol
Be aware that thisdiffers fro
m
the method of entering the
service mode (Vol +).
LED OFF
3.0sec
DISPLAY 5 - POWER
1:LAMP_ERROR 0
2 : TEMP_ERROR 0
2 : LAMP_TEMP 0
3:LAMP_COVER 0
4:FAN_ERROR 0
5:LAMP_DRIVER 1
6:LOWB_ERROR 0
7:AUDIO_PROT 0
8:D_OVP 0
10 : ATSC_OVP 0
SELF CHECK
-Numeral "1" means a fault was detected one time
-Numeral "0" means that no fault was detected
PUSH OPEN
POWER/STANDBY
POWER
TIMER LAMP
Indicators