– 15 –
KDF-E42A10/E50A10
K RM-YD003 RM-YD003
Use the following to determine the lamp and panel time of a set.
CONFIGRATION 00 SERVICE
CP18_COLOR_SYS 00 00A0 BE Micro
Press Channel-4
Press Channel-4
Reading Lamp and Panel time
After completing the changes exit service mode by turning off the set using the Remote Commander or the
power switch.
Exiting Service Mode
In standby mode, press the buttons on the Remote Commander sequentially, in rapid succession, as shown below:
1. Press Display , Channel 5 , Sound Volume + , Power ON
2. To enter BE-micro service menu, press JUMP 2 times.
3. To display the lamp time, press Channel-4.
The screen displays:
“ Total lamp time is 14 hours”
4. To display the panel time, press Channel-4.
The screen displays:
“ Total panel time is 14 hours”
5. To display the lamp time clear, press Channel-5
7 times and Channel-1.
To reset the lamp time press Channel-3 > MUTING > ENT.
WRITE (Character color is red) is momentarily displayed and the lamp time is reset to “0”.
Screen Display Method
m
GW_SPECIAL 34 SERVICE
LAMP_TIME 02 00000014 BE Micro
m
Press Channel-5 7 times,
Channel-1
GW_SPECIAL 34 SERVICE
PANEL_TIME 01 00000014 BE Micro
OPTION_E 20 SERVICE
LAMP 01 0000 BE Micro
m
To Next Page
Loading...
