126
English
3 Display data setting
This sets the data to be displayed on the main and sub-displays. The current value or the peak value (maximum, minimum and
peak-to-peak values) can be displayed on the main display. If the peak value is selected for the main display, the display can be
switched with the current value by pressing MODE/ENTER key. (The current value is the value selected in item 2 above.) The
current value, peak value or the judgment results when a comparator unit is connected can be displayed on the sub-display. If
the number of connected scale axes is set to “1” in item 2 above, the display goes blank when the unconnected axis is
selected as the display data. For example, if 1st axis only is selected in item 2 above, the respective display goes blank when
the 2nd axis is selected.
* When 1st and 2nd axes independent is selected for the addition/subtraction axis, the 1st axis is used.
Initial value
“
dSP” and subordinate menu sub-
display settings are necessary.
(For AUTO input, set the numbers
in the fourth and fifth digits.)
Number of
connected
scale axes?
For individual input:
Main display:
Addition/subtraction
axis*
Sub-display (left):
Minimum value
Sub-display (right):
Maximum value
For AUTO input:
• • 3 5 4 • • • • • • • • • •
Setting unnecessary
“dSP” and subordinate menu
main display settings are
necessary. (For AUTO input, set
the number in the third digit.)
(1)
(2)
What is to be
displayed on
the sub-
display?
What is to be
displayed on
the sub-
display?
“dSP” and subordinate menu
setting is necessary. (For AUTO
input, set the numbers in the
third to fifth digits.)
What is to be
displayed on
the main
display?
(Peak value for a combination
other than 1st and 2nd axes or
minimum and maximum
values, or blank display)
(Minimum and maximum values)
(1st axis, 2nd axis,
peak value)
(Minimum and maximum values)
(Other than minimum and
maximum values)
(Minimum and
maximum
values)
(Addition/
subtraction
axis*)
What is to be
displayed on
the sub-
display?
(Peak value for a combination
other than 1st and 2nd axes
or minimum and maximum
values)
(Initial value)
To Next Page
Loading...
