Sony MAP-S1 - Tuner Board Service; Tuner Board Component Handling and Reassembly

MAP-S1
23
2-16. TUNER BOARD
3 flexible flat cable (9P)
(CN101)
2 lower cushion
(antenna)
1 Cut the binding band (taiton).
4 shild
(lower)
5 sheet
(tuner)
ferrite core
(FC3)
guide line
flexible flat cable
(9P)
guide line
)HUULWHFRUH)&VHWWLQJ
filament tape
(sub material)
6 TUNER
board
upper
block
flexible
flat
cable
(9P)
binding band
(taiton)
TUNER
board
lower cushion
(antenna)
ferrite core
(FC3)
ferrite core
(FC3)
OK
NG
)OH[LEOHIODWFDEOH3VHWWLQJ
The tip is sideways.
Insert the flexible flat cable (9P)
under the binding band (taiton)
and the ferrite core (FC3).
The tip is Upper.
Note:
During reassembly, use new binding
band (taiton) to fasten the wires back in
place as they were before disassembly.