Rotor balancing F:5
General settings
To make general settings for the balancing func-
tion, press the MENU key and select ‘Settings’ >
‘General settings’, then use the F2 key to select
the ‘Balancing’ tab.
Your selection under ‘Counter rotational degrees’
affects the way the angles are displayed while
balancing.
When the box is not marked, angles are displayed
as shown in figure A.
When the box is marked, angles are displayed
as shown in figure B.
Marking ‘Ounce’ will show all weights in ounces
instead of grams.
‘Output unit’ is the transducer output, ACC VEL
or DISP.
Rotational
0°
+ 90°
A
Counter rotational
0°
+ 90°
B
To Next Page
Loading...
