SPM leonova emerald - Measurement with Edited Default Files

B:6 General measurement functions
B
3
1
Measurement with edited default files
Editing the measuring point data only temporarily
modifies the default file. Depending on the measuring
technique selected, different settings are available
for editing. In the example on the previous page,
only one parameter can be edited for temperature
measurement, namely ‘Variable speed’.
To the right is an example showing the default
settings for SPM HD measurement (1), all of which
can be edited. In the second screen shot (2), shaft
diameter and RPM have been input, and the meas-
uring time set to equal 10 revolutions.
After editing measuring point data, you can do one
of three things:
• ‘Close’ (3) simply closes the default file, without
saving the edited measuring point data or the
measuring results.
• To keep the edited measuring point data perma-
nently, use ‘Save as file’ (4) before closing the file.
• The choice ‘Save as new default settings’ (5) cre-
ates a new default file which you have to name
(6). For further information, see overleaf.
The name of the new default file is shown in the
measurement window (7).
2
6
7
4
5