Rotor balancing F:15
Graphical check of calculation results.
Split the correction mass: Input the number of rotor partitions to
distribute the correction mass between two of them.
Radial displacement: Input the change in radial distance to recalculate
the weight.
Calculate radial position of smaller/larger balancing weight (known
weight).
Weight removal: Show drill hole position.
Degrees to length: change from angle to length measured along
the rotor circumference.
Sum up weights: Replace all correction masses on the rotor by one.
Weight removal: Drill hole diameter and depth calculated for various
materials.
Alternatives for balancing weights
Leonova calculates a number of alternatives for correcting the unbalance:
To Next Page
Loading...
