SPM leonova emerald - Temperature Measurement with Default File

C:8 Measurement techniques always included
BC
Temperature measurement with default file
The default file for temperature measure-
ments is located in the ‘User defined’ window
(1). There are no settings under ‘Measuring
point data’.
The result is displayed with a decimal, but
please note that the accuracy of the SPM
lasertachometer/IRtemperatureprobeis
±2.5°C.
Thechangefrom°Cto°Fismadeunder
‘General settings’ (2) in the SETTINGS win-
dow. Switching from one unit to the other
will re-calculate all saved results and display
them in the active unit.
Afterpressingthemeasurekey(M/S)you
can select type of material (3) to obtain as
accurate readings as possible.
Select material to be measured (emissivity)
withRIGHT/LEFTarrowkeys:
- Paint
- Black body
- Iron rusted
- Iron oxidized
- Aluminium unoxidized
- Aluminium oxidized
- Lead oxidized
- Brass polished
- Brass oxidized
-Copperroughpolished
-Copperblackoxidized
PressF1‘Continue’orENTERtostopread-
ing.SavetheresultwiththeM/Skey.
To see or delete measurement(s) before sav-
ing,pressF1‘Measuringresult’(4)toseethe
result window. PressSHIFT+F2tosetade-
fault comment or link a voice recording to the
result.SeeChapterB,Comments.PressF2to
gotographics(seeChapterB,Graphics)
To save the result, press MENU and select
‘Save as’. Select ‘Save a file’ and input a
name via the keyboard window. Press ENTER
to save.
Formanualinputoftemperature,press
ENTER and input the temperature via the
keyboard window.
4
1
2
3