P340 flexiprobe Operation Manual 10
If both a CF card and a USB flash drive are present, the controller will use the USB flash drive for
recording.
For more information about USB flash drives refer to Section 7.1.
4.1.5 Keyboard
Connect the supplied keyboard via the PS/2 connector in the I/O panel (Item 15 in Figure 2.3).
NOTE: Only the supplied keyboard is compatible with the controller.
4.1.6 Headset
The optional headset allows you to record and hear audio commentary in your video recordings. Connect
the headset to the audio socket in the I/O panel (Item 11 in Figure 2.3).
4.2 Pushrod reel
Connect the link cable on the pushrod reel to the socket on the back of the controller. Tighten the
connectors finger-tight but do not use a wrench, spanner or pliers.
4.3 Cameras and accessories
Warning when fitting or changing the camera, universal flexi or Sondes the internal electrical
connectors are exposed to the elements. Fit the cameras and accessories in a dry, clean environment.
4.3.1 Camera
Fit and hand-tighten the camera to the rod termination socket, or to an accessory such as the flexisonde.
Make sure there is no dirt in the lens recess. If necessary, refer to Section 11.3 Care and Maintenance
section and clean the camera lens.
To Next Page
Loading...