P340 flexiprobe Operation Manual 35
We recommend the use of a sonde and RD7000+DL to locate points of interest with more confidence.
6.3 Deploying the camera
To deploy the camera, first release the brake gently and rotate the reel. When a sufficient amount of
pushrod is free, insert the camera into the pipe. Push the pushrod into the pipe by hand and rotate the reel
if you need more length. Particularly as they can self-propel and cause injury if not monitored carefully.
NOTE: Pearpoint recommends adjusting the brake slowly to prevent excessive free movement of the reel.
Adjust the brake lever position by pulling out and turning.
Zero the Rod Counter
Zero the counter to provide accurate location results in your pictures, videos and observations. When the
pushrod is in the desired start position:
Press F10 on the keyboard, or press the ▲ and ▼ arrows on the keypad simultaneously,
Make sure that the counter changes to ‘0ft’ or ‘0.0m’.
NOTE: You can reset the pushrod counter to zero at any time. This operation can’t be undone.
6.4 Video recording
Recording video is simple. Before you begin a recording, make sure you have installed a high-quality
Compact Flash card or USB flash drive with sufficient free space to store your recording. Refer to Section
7.1 for more information about using and selecting Compact Flash cards and USB drives.
CAUTION: Do not remove the memory storage device or switch the controller off during the recording
process. Doing so may corrupt all data on the device and cause the controller to crash.
1. To begin recording press ○ ;
Now enter your JOB details by entering the client name, site address, survey
start and finish references. Then press ○ again to begin recording
Alternatively, press ● again without entering the details to start a survey
quickly (without site data). See Section 9.1 for more details about JOBS or
Section 5.8.1 to disable the quick job creation option.
2. A red dot will appear on-screen to indicate recording has begun.
3. The file name is shown briefly on the screen, followed by the maximum recording time remaining.
4. Video titles are shown on the screen if enabled. See Sections 5.11 for information on how to set
company and/or text pages titles.
To Next Page
Loading...