SPX Pearpoint Flexiprobe P340 - W-Skids

P340 flexiprobe Operation Manual 13
 Install one 1.4” (35mm) skid adaptor on the rear end of the flexisonde.
 Install one 2.8” (70mm) skid on the 1.4” (35mm) skid adaptor; ensure that the rear skid is
positioned so that the camera is level when placed on a flat surface
 If the pipe is larger than 2.8” (70mm), use brushes to help level and center the camera in the
pipe.
NOTE: 2-off 1” (25mm) spring clamps to be used on 1” (25mm) camera and 1” (25mm) sonde or
termination or 1-off 1.4” (35mm) spring clamps to be used on 1.4” (35mm) flexisonde or 2” (50mm) camera.
Example configuration 2
 Take a 1” (25mm) camera and flexisonde suitable for a 2” (50mm) or larger pipe:
 Connect the flexisonde to the pushrod termination socket.
 Connect the camera to the flexisonde socket.
 Install one 1” (25mm) skid adaptor on the camera.
 Install one 1” (25mm) skid adaptor on the flexisonde; ensure that the rear skid is positioned so that
the camera is level when placed on a flat surface.
 If the pipe is larger than 2” (50mm) install the 2.8” (70mm) brush on top of the 1” (25mm) skid
adaptor and use brushes if required.
4.3.6 W-Skids
The optional 8” (200mm) W-Skids are used to center the 2” (50mm) camera in 8” (200mm) pipes and to
help centering in larger pipes.
To install the skids, locate each of the three w-skids onto the collar and fix firmly with two M5 x 12mm
screws each. The skids are asymmetrical and can only be fitted one way round.
Loosen the two M6 x 20mm screws that hold the two halves of the collar together and insert the flexi with
the camera attached into the collar. Ensure the camera abuts the screw end of the collar, and tighten the
two screws evenly and firmly.