P340 flexiprobe Operation Manual ii
Installation, operation and safety precautions
WARNING: The P340 flexiprobe, including its component parts are heavy. If available, use the wheels
to assist transport. Observe heavy-lifting safety practices when lifting any component of this system. Refer
to the specifications in Appendix 11.5 for a description of the system’s dimensions and weights.
WARNING: If system connects to mains operated equipment then the external equipment must be
earthed in accordance with the manufacturer’s instructions. Failure to comply with this may cause the unit
to become live and a LETHAL HAZARD.
Please observe your company, region and country’s Standard Code of Practice for surveying underground
utilities with CCTV equipment, if applicable, when using this equipment.
WARNING: Foul systems can be a source of serious biological hazards. Wear appropriate protection
(PPE) when handling the P340 flexiprobe.
WARNING: The camera will get hot with use. This is normal. Exercise care when handling the camera,
consider gloves.
WARNING: System components must NOT be connected or disconnected when the power is on.
Do not touch any connectors while the system is live
Take care to ensure that video and power cables don’t become entangled in the reel. Cable ties are
recommended and will not impede system performance.
Always store the P340 flexiprobe system in a clean and dry environment.
WARNING: Always carry out a risk assessment of the site to be inspected. This equipment is NOT
approved for use in areas where potentially explosive (or otherwise hazardous) gases, vapors, liquids or
solids may be present.
Ensure that standard safety precautions for working in hostile environments are followed. Including manual
handling, biological hazards and personal injury.
The P340 flexiprobe system requires connection to a protective earth; if in doubt, consult a qualified
electrician. Electrical equipment is factory tested for electrical safety. Routine inspection is recommended
(and may be required by law) to maintain this level of protection. If you are unsure, contact your local safety
authority for advice.
Always use heavy-duty industrial gloves when withdrawing rod from a sewer.
The distance counter should only be used as an estimation, Radiodetection recommends the use of a
sonde and a Radiodetection cable locator to accurately locate positions of interest. Especially prior to
construction works.
Always ensure that cabling is properly connected.
Always switch the system on and off using the controller switch.
To Next Page
Loading...