P340 flexiprobe Operation Manual iv
Maintenance
Clean and sanitize the P340 flexiprobe system at regular intervals and after conducting an inspection.
Consider the work environment and clean / sterilize appropriately before shipment, following any applicable
laws and guidelines.
Always keep all connectors covered with their protective caps when the equipment is not in use to prolong
the life of your product. Do not apply grease, lubricants or other fluids to any of the connectors or pogo
pins in the system (especially to the camera connection). The supplied grease is provided to apply in small
doses to any o-rings in order to keep the waterproof seal.
Do not dismantle any component of this system unless directed by this operation manual. Dismantling
components not specified by this manual may void the product warranty.
Pearpoint recommends that only authorized service centers carry out service of this product. Service
elsewhere will void the warranty.
CAUTION: The rod guide assembly (see below figure 0.1) must be reviewed regularly to determine whether
a replacement is needed. If the rod wears through the guide it will begin to wear through the metal
structure. Wear to the metal components of the system may cause potential hazards to the user (typically
sharp edges or electrical malfunction). Spare rod guides can be purchased and fitted by competent
mechanical technicians using a screwdriver. Spare rods and various components are available to
purchase as repair kits.
Figure 0.1 Rod guide assembly
For information regarding any service needs, please visit www.radiodetection.com or contact your local
Radiodetection or Pearpoint representative or dealer.
To Next Page
Loading...