Stihl MS 200 - Version with One-Part Tank Vent System; Removing and Installing (MS 200 T); Version with Multi-Part

108 MS 200, MS 200 T
: Position the filter (1) on the seat
(arrow) and press it in as far as
stop.
– Reassemble all other parts in the
reverse sequence.
14.6.4 Removing and Installing
(MS 200 T)
Version with one-part
tank vent system
– Remove the air filter, b 14.1
: Pry the tank vent (1) out of its
seat (arrow).
– Pull the tank vent (1) out of the
hose.
Always install a new tank vent.
161RA374 TG
1
1
162RA068 TG
– Position the new tank vent (1) so
that it fits the hose and points
towards the seat.
: Push the tank vent (1) into the
hose and into its seat (arrow) as
far as stop.
– Reassemble all other parts in the
reverse sequence.
14.6.5 Removing and Installing
(MS 200 T)
Version with multi-part
tank vent system
– Remove the chain sprocket
cover, bar and chain, b 5
– Remove the handle housing,
b 12.4
: Disconnect the tank vent (arrow).
– Check the tank vent and replace
if necessary.
Always install a new tank vent – the
new tank vent is supplied with an
installing sleeve.
1
162RA069 TG162RA070 TG
: Pull out the stub (arrow).
: Pull the valve (arrow) out of its
seat inside the tank.
– Check the valve (arrow) and
replace if necessary.
– Reassemble in the reverse
sequence.
– Press home the valve (arrow)
until it snaps into its seat.
: Fit the stub (1) so that the
mushroom valve's rubber nipple
(arrow) engages the stub's
opening.
162RA071 TG
161RA382 TG
162RA073 TG
1