Stihl MS 200 - Oil Pump

87MS 200, MS 200 T
: Line up the connector (1) so that
the shoulder (arrow) is visible and
points towards the oil pump's
stub.
– Push the connector (1) into its
seat as far as stop.
– Install the oil pump and push the
worm into position, b 13.4
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
13.4 Oil Pump
– Troubleshooting, b 4.3
– Remove the clutch drum, b 6
: Take out the screws (arrows).
– Remove the covers(1 and 2).
161RA284 TG
1
161RA285 TG
1
2
: Pull the worm (1) out of the oil
pump.
– Check the worm (1) and replace if
necessary
– Pull off the oil suction hose (1).
: Take out the screws (arrows).
: Turn the oil pump (1) clockwise
until the stub (arrow) slips out of
the connector (2).
161RA286 TG
1
161RA287 TG
1
161RA288 TG
1
2
– Check the oil pump (1) and
replace if necessary
– Inspect the oil suction hose and
replace if necessary, b 13.2
– Check the connector (2) and
replace if necessary, b 13.3
The ignition lead (1) must be
properly seated in the guides
(arrows) since it might otherwise be
pinched.
– Place the oil pump in position.
: Turn the oil pump (1)
counterclockwise until the stub
(arrow) is properly seated in the
connector's bore (2).
161RA156 TG
1
161RA289 TG
1
2