83MS 200, MS 200 T
– Place the handle housing in
position.
: Push the tank vent hose (1) and
fuel hose (2) through the holes
(arrows).
: Push the impulse hose (3) on to
the nipple (arrow)
– and make sure it does not slip
off during the following
operatons.
Do not pull the hose flanges
(arrows) through the holes
– they are intended to act as stops.
2
161RA272 TG
3
1
161RA0273 TG
– Coat the flange of the manifold
with STIHL Press Fluid, b 16
– Position the handle housing
against the manifold.
: Wind a piece of string around the
manifold flange.
: Pass the ends of the string
through the opening in the handle
housing and then pull the
manifold flange (1) through the
opening.
: Fit the sleeve (1) and washer (2).
161RA274 TG
161RA275 TG
1
161RA276 TG
1
2
– Install the tank vent, b 14.6.2
– not necessary on versions with
"tank vent installed in tank
housing".
: Connect the wiring harness (1) to
the short circuit wire (2).
– Install annular buffer on the oil
tank, b 11.2
: Fit the screws (arrows).
– Fit the screw on the handlebar.
– Install the carburetor, b 14.2
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
– Check operation.
161RA277 TG
1
2
161RA429 TG
To Next Page
Loading...
