Stihl MS 200 - Removing and Installing the Handle Housing (MS 200)

81MS 200, MS 200 T
– Line up the long throttle rod (1) –
the curved end (2) must be one
the double throttle lever.
: Carefully push the long throttle
rod (1) into the double throttle
lever and throttle trigger (arrows).
The double throttle throttle lever
may fall out or the interlock lever
and throttle trigger may pop out.
– Check all rods – the levers must
be seated in the guides and rods
attached to the levers.
: Push the link (1) into the holes
(arrows) as far as stop.
– Fit the handle molding and switch
lever, b 12.1.2
– Tightening torques, b 3.5
– Check operation.
2
1
162RA039 TG
1
162RA042 TG
12.4 Removing and Installing
the Handle Housing
(MS 200)
– Remove the carburetor, b 14.2
– Remove the tank vent, b 14.6.2
– not necessary on versions with
"tank vent installed in tank
housing".
– Remove annular buffer from the
oil tank, b 11.2
: Disconnect wiring harness (1)
from the short circuit wire
connector (2).
: Take out the screws (arrows).
– Remove screw from handlebar.
161RA168 TG
1
2
161RA264 TG
: Remove the sleeve (1) and
washer (2).
: Lift the handle frame (1) and push
out the manifold (arrow).
161RA068 TG
1
2
161RA265 TG
1