Stihl MS 200 - Removing and Installing the Carburetor (MS 200 T)

93MS 200, MS 200 T
14.2.1 Removing and Installing
the Carburetor (MS 200 T)
– Remove the air filter, b 14.1
– Remove the filter base, b 14.1.2
– Open the fuel tank cap and drain
the fuel tank.
– Collect the fuel in a clean
container, b 1
Pull off the carburetor only when the
tank cap is open.
Pry out the tank vent and put it to
one side, b 14.6.4
: Disconnect the fuel hose (arrow).
: Take out the screw (arrow).
– Pull out the shutter (1) for
summer/winter operation, check
it and replace if necessary.
162RA0057 TG
161RA335 TG
1
: Disconnect the choke rod (1).
: Push out the grommet (2).
: Pull out the carburetor (1) until
the throttle rod (2) can be
disconnected.
: Pull off the grommet (1), check it
and replace if necessary.
– Check the carburetor and service
or replace if necessary.
1
162RA058 TG
2
2
162RA059 TG
1
1
162RA060 TG
Check that the sleeve (2) and
washer (1) are in place.
– Check the choke and throttle rods
and replace if necessary,
b 12.3.2
: Push the grommet (1) on to the
stub (arrow) as far as stop.
– Place the carburetor on the collar
studs.
: Attach throttle rod (1) to lever
(arrow) on throttle shaft.
162RA061 TG
2
1
162RA062 TG
1
1
162RA084 TG