58 MS 200, MS 200 T
9.5.5 Ground Wire
A faulty ground wire may impair or
prevent operation of the short circuit
wire.
MS 200
The ground wire is combined with
the short circuit wire in a wiring
harness. If damaged, the complete
wiring harness must be replaced
– Check for contact and continuity
and replace wiring harness if
necessary, b 9.5.3
MS 200 T
The ground wire is fitted to the
handle housing and can be
removed and installed separately.
– Take out the screws and remove
the control lever and handle
molding, b 12.3
– Remove the annular buffer
(arrow) and ground wire (1),
b 11.2.1
162RA005 TG
1
: Pull out the contact spring (1).
– Disconnect the ground wire (2).
– Check the contact spring (1) and
ground wire and replace if
necessary
– Push the ground wire on to the
contact spring as far as stop.
: Push the contact spring (1) with
ground wire (2) into the guides
(arrows).
– Install the annular buffer,
b 11.2.1
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
1
2
162RA006 TG
1
2
162RA007 TG
To Next Page
Loading...
