Stihl MS 200 - 14.4.2 Inlet Needle

96 MS 200, MS 200 T
: Fit the screws (arrows).
– Check position of diaphragm and
gasket, then tighten down all
screws firmly in a crosswise
pattern..
– Reassemble all other parts in the
reverse sequence.
14.4.2 Inlet Needle
– Remove the metering
diaphragm,
b 14.4.1
: Take out the screw (arrow).
161RA316 TG161RA317 TG
: Pull the inlet control lever (1) with
spindle (2) out of the inlet
needle’s groove.
The small spring under the inlet
control lever may pop out.
: Remove the inlet needle (1).
– Remove the spring (2). Inspect
and replace if necessary.
: If there is an annular indentation
(arrow) on the sealing cone of the
inlet needle, fit a new inlet
needle.
161RA318 TG
2 1
161RA319 TG
1
2
533RA309 TG
: Fit the inlet needle (1).
: Fit the spring (2) in the bore.
: Position the inlet control lever (3)
with spindle (2) on the spring’s
seat (arrow) first, then slide the
inlet control lever’s clevis into the
groove in the inlet needle (1).
Make sure the spring locates on the
control lever’s nipple.
– Press the inlet control lever down
and secure it with the screw.
– Check that inlet control lever
moves freely.
– Install the metering diaphragm,
b 14.4.1
161RA320 TG
1
2
161RA321 TG
21 3