26 MS 200, MS 200 T
7.5 Pins
The anchor pins secure the springs.
Worn pins must be replaced
– the brake spring may pop out
during this operation.
All parts have been removed from
the pins in the following illustrations
for greater clarity.
: Use a suitable tool to pull out the
pin bar (1), check it and replace if
necessary.
: Line up the pin bar – the lug
(arrow) must point towards the
edge of the cover.
– Push the pin bar (1) into its seat in
the cover as far as stop.
1
161RA046 TG
1
161RA047 TG
: Use a suitable tool to pull the pins
(1 and 2) out of the cover.
– Before installing the new pin (1),
coat its knurled shank with
Loctite, b 16
: Position the new pin (1) in the
bore (arrow) so that the knurling
on the pin meshes with the
existing knurling in the bore.
Turn pin back and forth as
necessary.
161RA048 TG
2
1
161RA049 TG
1
View from air filter side.
: Carefully tap home the pins (1
and 2) to obtain the following
dimensions:
Pin (1) a = 6.3 mm
Pin (2) b = 13.4 mm
The pins must be driven home
squarely.
– Reassemble all other parts in the
reverse sequence.
– Lubricate the brake lever and flat
spring, b 16
161RA411 TG
a
b
1
2
To Next Page
Loading...
