Stihl MS 200 - Removing and Installing the Handle Housing (MS 200 T)

84 MS 200, MS 200 T
12.5 Removing and Installing
the Handle Housing
(MS 200 T)
– Remove the carburetor,
b 14.2.1
– Remove the tank vent, b 14.6.4
– not necessary on versions with
"tank vent installed in tank
housing".
– Remove annular buffer from the
oil tank, b 11.2.1
– Disconnect the short circuit wire,
b 9.5.3
: Take out the screw (arrow).
– Remove screw from handlebar,
b 11.5
: Remove the sleeve (2) and
washer (1).
161RA163 TG162RA061 TG
2
1
: Lift the handle frame (1) and push
out the manifold (arrow).
: Pull the tank vent hose (1) and
the fuel hose (2) out of the handle
housing.
: Disconnect the impulse hose (3).
– Remove the handle housing,
check and replace if necessary
– Check the ground wire and
contact spring and replace if
necessary. b 9.5.5
– Check the interlock lever and
throttle trigger and replace if
necessary, b 12.3
– Check the choke and throttle rods
and replace if necessary,
b 12.3.2
– Check the switch shaft and
replace if necessary, b 12.1.2
– Check shutter for summer/winter
operation and replace if
necessary, b 14.2.1
162RA043 TG
1
162RA044 TG
1
3
2
: Pull the cover (1) out of the
handle housing.
– Inspect the cover and replace if
necessary.
: Fit the cover (1). Push the pegs
into the holes.
: Pull the pegs (arrows) into the
holes and make sure they are
properly seated.
162RA045 TG
1
162RA046 TG
1
162RA047 TG