85MS 200, MS 200 T
– Remove the switch shaft,
b 12.1.2
: Take out the screw (arrow).
– Pull out the handlebar (1), check
it and replace if necessary.
– Reassemble in the reverse
sequence.
– Place the handle housing in
position.
: Push the tank vent hose (1) and
fuel hose (2) through the opening
(arrow).
: Push the impulse hose (3) on to
the nipple – and make sure it
does not slip off during the
following operatons.
162RA048 TG
1
162RA049 TG
1
3
2
– Coat the flange of the manifold
with STIHL Press Fluid, b 16
– Position the handle housing
against the manifold.
: Wind a piece of string around the
manifold flange.
: Pass the ends of the string
through the opening in the handle
housing and then pull the
manifold flange through the
opening.
: Fit the sleeve (2) and washer (1).
162RA050 TG
1
162RA051 TG162RA052 TG
2
1
– Install the tank vent, b 14.6.4
– not necessary on versions with
"tank vent installed in tank
housing".
– Push the short circuit wire on to
the contact spring, b 9.5.3
– Install annular buffer on the oil
tank, b 11.2.1
– Fit the screw on the
handlebar,b 11.5
: Fit the screw (1).
– Install the carburetor, b 14.2.1
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
– Check operation.
1
161RA225 TG
To Next Page
Loading...
