Stihl MS 200 - Removing and Installing the Filter Base (MS 200); Removing and Installing the Carburetor (MS 200)

91MS 200, MS 200 T
14.1.1 Removing and Installing
the Filter Base (MS 200)
Remove the air filter, b 14.1
: Unscrew the nuts (arrows).
– Pull off the filter base (1), check it
and replace if necessary.
Always use new self-locking nuts.
– Reassemble in the reverse
sequence.
– Tightening torques, b 3.5
161RA305 TG
1
14.1.2 Removing and Installing
the Filter Base (MS 200 T
Remove the air filter, b 14.1
: Unscrew the nuts (arrows).
– Pull off the filter base (1), check it
and replace if necessary.
: Check the foam element (2) and
clean or replace if necessary.
Always use new self-locking nuts.
– Reassemble in the reverse
sequence.
– Tightening torques, b 3.5
162RA056 TG
2
1
14.2 Removing and Installing
the Carburetor (MS 200)
– Remove the air filter, b 14.1
– Remove the filter base, b 14.1.1
– Open the fuel tank cap and drain
the fuel tank.
– Collect the fuel in a clean
container, b 1
Pull off the carburetor only when the
tank cap is open.
: Disconnect the fuel hose (arrow).
– Pull out the carburetor (1) until
the throttle rod (2) is above the
peg (3).
: Push the throttle rod (2) in
direction of tank vent and
disconnect it from the throttle
lever (arrow).
161RA307 TG161RA308 TG
2
3
1