Stihl MS 200 - Felling Instructions:; Escape path; Buttress roots; Gunning sight

20 MS 200, MS 200 T
: Fit the clutch shoes (1) over the
arms (2).
: Clamp the clutch in a vise.
The tips (arrows) must match up
and the series numbers on the
clutch shoes must be on the same
side as the raised hexagon.
161RA015 TG
12
161RA014 TG
Attach the springs on the side
opposite the raised hexagon
(arrow).
: Attach one end of each spring (1)
to the clutch shoes.
: Use the hook (2) 5910 890 2800
to attach the other ends of the
springs and press them firmly into
the clutch shoes – do not
overstretch the springs.
: Check the clutch – all springs
(arrows) must be properly
attached.
161RA017 TG
2
1
161RA018 TG
: Position the clutch on the
crankshaft stub so that the raised
hexagon (arrow) faces outwards.
: Use the hexagon (arrow) to
screw the clutch (1) onto the
crankshaft. Check position of the
locking strip and then tighten
down the clutch firmly – left-hand
thread.
– Tightening torques, b 3.5
– Remove the locking strip from the
cylinder.
– Reassemble all other parts in the
reverse sequence.
161RA019 TG
1
161RA020 TG