Stihl MS 200 Service Manual

2 MS 200, MS 200 T
Contents
14. Fuel System 90
14.1 Air Filter 90
14.1.1 Removing and Installing
the Filter Base
(MS 200) 91
14.1.2 Removing and Installing
the Filter Base
(MS 200 T 91
14.2 Removing and Installing
the Carburetor
(MS 200) 91
14.2.1 Removing and Installing
the Carburetor
(MS 200 T) 93
14.3 Leakage Test 94
14.4 Servicing the
Carburetor 95
14.4.1 Metering Diaphragm 95
14.4.2 Inlet Needle 96
14.4.3 Pump Diaphragm 97
14.4.4 Choke Shaft / Choke
Shutter 98
14.4.5 Throttle Shaft / Throttle
Shutter 99
14.4.6 Accelerator Pump 101
14.4.7 Adjusting Screws 102
14.5 Adjusting the
Carburetor 103
14.5.1 Basic Setting 103
14.5.2 Standard Setting 104
14.5.3 Removing and Installing
the Intake Manifold 105
14.5.4 Impulse Hose 105
14.6 Tank Vent 106
14.6.1 Testing 106
14.6.2 Removing and Installing
(MS 200)
Version with one-part
tank vent system 107
14.6.3 Removing and Installing
(MS 200)
Version with multi-part
tank vent system 107
14.6.4 Removing and Installing
(MS 200 T)
Version with one-part
tank vent system 108
14.6.5 Removing and Installing
(MS 200 T)
Version with multi-part
tank vent system 108
14.7 Fuel Intake 109
14.7.1 Pickup Body 109
14.7.2 Fuel hose (MS 200)
Version with one-part
tank vent system 109
14.7.3 Fuel hose (MS 200)
Version with multi-part
tank vent system 110
14.7.4 Fuel hose (MS 200 T)
Version with one-part
tank vent system 110
14.7.5 Fuel hose (MS 200 T)
Version with multi-part
tank vent system 112
14.8 Removing and Installing
the Tank Housing 112
15. Special Servicing
Tools 114
16. Servicing Aids 116

Stihl MS 200 Specifications

General

Guide Bar Length	30-40 cm
Chain Oil Capacity	0.22 L
Chain pitch	3/8"
Engine Power	2.0 kW
Displacement	35.2 cc
Weight (without cutting equipment)	4.2 kg