Stihl MS 200 - Winter Operation; Information Before You Start; Starting; Stopping the Engine

34 MS 200, MS 200 T
– Line up the cylinder gasket (1) so
that its tab (arrow) is on the same
side as the nipple (2) for the
impulse hose.
: Place the cylinder gasket (1) in
position.
– Inspect the intake manifold (2)
and replace it if necessary – even
very minor damage can result in
engine running problems, b 4.7
: Remove the retaining plate (1).
– Pull off the intake manifold (2).
161RA085 TG
1
2
161RA086 TG
1
2
– Push the manifold (1) on to the
intake stub.
: Line up the manifold.
– The tab on the manifold must
locate against the left side (see
illustration) of the lug (arrow).
– Position the retaining plate (3) so
that the rib (1) lines up with the
raised molding on the manifold
(2).
: Push the retaining plate (3) on as
far as stop – the edge (arrow)
must be in line with the cylinder
fin.
161RA087 TG
1
161RA088 TG
2
1
3
: Inspect and clean the sealing
face (arrow) and remove any
gasket residue.
– Also check the sealing faces on
the cylinder intake and exhaust
ports.
The sealing faces must be in perfect
condition. If the sealing faces are
damaged, install a new cylinder.
: Slide the wooden assembly block
(1) 1108 893 4800 between the
piston and crankcase.
Take care not to displace or damage
the cylinder gasket.
161RA089 TG161RA090 TG
1