40 MS 200, MS 200 T
– Heat the area of the bearing seat
to about 230°C (446°F).
The roller bearing (1) drops out as
soon as this temperature is
reached.
– Heat the area of the bearing seat
to about 230°C (446°F).
– Position the roller bearing so that
the nylon ring faces outwards.
: Push the roller bearing home as
far as stop.
This operation must be carried out
quickly because the bearing
absorbs heat and begins to expand.
161RA114 TG
1
161RA115 TG
Clutch side of crankcase
: Use a suitable punch to carefully
drive out the oil seal.
: Check and clean the crankcase
or replace if necessary.
If this half of the crankcase is in
order, install a new roller bearing.
– Heat the area of the bearing seat
to
about 230°C (446°F).
161RA116 TG161RA117 TG161RA118 TG
1
The roller bearing (1) drops out as
soon as this temperature is
reached.
– Heat the area of the bearing seat
to
about 230°C (446°F).
– Position the roller bearing so that
the nylon ring faces outwards.
: Push the roller bearing home as
far as stop.
This operation must be carried out
quickly because the bearing
absorbs heat and begins to expand.
After the crankcase halves have
cooled, fit the short circuit wire in the
ignition side of the crankcase.
: Push the grommet (1) –
rectangular opening first – over
the connector (2).
161RA119 TG161RA120 TG
12
To Next Page
Loading...
