Stober SC6A062 Commissioning Instructions

STOBER 8 | Connection
03/2020 | ID 442793.03
49
8.3.3.3 UL-compliant connection of the grounding conductor
Note that UL-compliant operation requires just a single grounding conductor.
The grounding at terminal X10 of the SC6 drive controller must not be used for protective grounding. The housing for the
drive controllers must be connected to the protective grounding using the M6 ground bolt (4.0 Nm, 35Lb.inch).
You will need an open-ended wrench or external hex key with a width across flats of 10mm.
Observe the order for assembly:
1
4
5
2
3
Fig.11: Connection of the grounding conductor
1 M6 ground bolt
2 Contact disk
3 Cable lug
4 Washer
5 Nut
The contact disk, washer and nut are supplied with the drive controller.
In order to dimension the grounding, it must be ensured that the upstream fuse is triggered in the event of a short circuit.

Stober SC6A062 Specifications

General

Brand	Stober
Model	SC6A062
Category	Controller
Language	English