Stoll FS - Repairs and Oil Changes

B58FZS 0000000078 EN 002 104
SERVICING
8.2.6 Service instructions for oil changes
The front loader is supplied by the oil circulation of the tractor.
 Observe the oil change intervals specified for the tractor.
 Before performing an oil change, lower the front loader onto the ground.
 After an oil change or after working on the hydraulic system, move the front loader carefully to all
end positions without a load to remove any air that might have entered.
8.3 Repairs
⚠ WARNING
Mortal danger and material damage caused by repair work carried out incorrectly!
Repair work carried out incorrectly can impair the safety of the front loader and can lead to serious
accidents and injuries.
 Repair work should only be performed by an authorised specialised workshop.
Repairs involve the replacement and repair of components. This is only necessary if components are
damaged after wear or due to external circumstances.
The specialised workshop must:
 Perform all required repair work professionally and complying with the applicable regulations and
according to the rules of engineering.
 Worn or damaged parts should never be provisionally repaired.
 Only use original or approved spare parts for repairs (see 10.1 Spare parts).
 Replace the gaskets.