Stoll FS - Operating the Hydraulic Implement Locking Mechanism

81 B58FZS 0000000078 EN 002
OPERATION
6.4.3 Operating the hydraulic implement locking mechanism
⚠ WARNING
Risk of injury due to implements falling down!
If not installed or operated correctly, the implement can fall down. This can cause serious injury to
persons standing in the surrounding area.
 The hydraulic implement locking mechanism must only be installed by a specialist workshop.
 Only use switches that are approved by STOLL.
 Set the implement on the ground or on a safe support before using the implement locking function.
Opening the implement locking mechanism:
(1) Push the locking bolt slightly down while
actuating the switch.
 The lamp lights up.
(2) Use the scooping function.
 The implement locking mechanism is open.
Closing the implement locking mechanism:
(1) Actuate the switch.
(2) Use the scooping function.
 The implement locking mechanism is closed.
The lamp is off.
The implement locking mechanism can
also be operated with STOLL Pro Control
(see 6.1.4 STOLL Pro Control).
Check the implement locking mechanism:
(1) Check that the locking pins engage correctly
in the eyelets of the implement.
 The implement locking mechanism is
checked.
Fig. 71 Hydro-Lock switch
Legend
1 Locking bolt
2Lamp
3 Switch
11
22
33
B075
Fig. 72 Checking the hydraulic implement locking
mechanism
Legend
1 Locking pin
2 Eyelet
11 22
B08T
11
22
11
22