B58FZS 0000000078 EN 002 64
OPERATION
6Operation
6.1 Operating elements
6.1.1 Basic controls with levers
⚠ WARNING
Possible risk of injury due to uncontrolled movement of the front loader!
If the control unit was not actuated for a longer period of time, there may be e.g. temperature differences
between the hydraulic fluid and the control unit. This can cause the control valves to jam and the front
loader moves uncontrollably. This may result in serious accidents.
At ambient temperatures lower than 10 °C and when the front loader is not used for longer than
15 minutes, always first actuate the scooping and dumping functions at a standstill to warm up the
control unit.
Only use the lifting and lowering functions after the warm-up phase.
⚠ WARNING
Possible risk of injury due to the implement tipping over!
On FS front loaders, the float position for the implement may not be activated for the scooping and
dumping functions. This could cause the implement to tip over unintentionally to the rear. This may
result in serious accidents.
The activation of the float position must be ruled out through the assembly on FS front loaders. If
this is not the case, work with the front loader must be stopped immediately and the specialist
workshop must be contacted, to have the float position deactivated for the scooping and dumping
functions. The front loader may only be used again when the float position has been deactivated for
the scooping and dumping functions.
To Next Page
Loading...
