53 B58FZS 0000000078 EN 002
START-UP
5Start-up
5.1 Initial operation
The initial operation is executed at a specialised workshop. This also includes mounting of the front
loader as well as a functional check.
Obtain instruction from the specialised workshop and ask questions if necessary.
Read the operating instructions before initial use.
After the first 5 hours of operation, have a specialised workshop re-tighten all of the mounting
screws.
Check all of the front loader functions without a load.
5.2 Check before each start-up
Before each start-up, check all of the points on the checklist.
Fix any observed defects in a safe position and location.
Only use the front loader if proper and safe operation is ensured.
Checks See also Completed
Before mounting the front loader
Are the safety labels on the tractor and on the front loader complete and in
order?
Section 2.10
Adhesive safety label
Are the brake pedals connected? Section 5.3.1
Preparations on the
tractor
Hydraulic oil: Is there enough oil?
Operating
instructions of the
tractor
Is the front axle turned off?
Is the shut-off valve of the front power lift closed?
Is the pressure of the tires sufficient for operating the front loader?
Is the correct counterweight mounted on the rear? Section 5.3.2
Ballasting
Are the fixing screws of the mounting parts tightened? Section 5.1 Initial
operation
Are the mountings (bearings and sliding surfaces) on the mounting parts clean,
free from paint, and greased?
Section 8.1.1
Lubrication points
Are the front loader locking mechanisms lubricated? Section 8.1.1
Lubrication points
During mounting
Are the hydraulic lines connected correctly? Section 6.3
Operating the
hydraulic couplings
Is the electric cable of the front loader connected?
Are the front loader locking mechanisms positioned correctly? Section 5.4.1
Adjusting the FS and
FZ 8 to 50 front
loader locking
mechanism,
Section 5.4.2
Adjusting the "Double
locking mechanism"
FZ 50 to 100 front
loader locking
mechanism
To Next Page
Loading...
