Stoll FS - Skid-Steer Change Frame; Reinforced Euro Change Frame (FZ 100)

B58FZS 0000000078 EN 002 34
STRUCTURE
3.5.6 Skid-steer change frame
These change frames are installed on FS and
FZ 8 to 20 front loaders.
They are intended for mounting implements
complying with the skid-steer standard.
The implement is attached to the locking hooks
using the lever.
3.5.7 Reinforced Euro change frame (FZ 100)
The structure of this change frame is similar to
the FS and FZ 8 to 80.1 Euro change frame.
However, they are designed for higher loads and
are always equipped with a hydraulic implement
locking mechanism (see 4.1.2 Hydraulic
implement locking mechanism – Hydro-Lock).
Fig. 15 Skid-steer change frame
Legend
1 Lever
2 Locking hooks
B076
11
22
Fig. 16 Reinforced Euro change frame (FZ 100)
Legend
1 Upper cross bar
2 Support with hydraulic couplings for the
3rd/4th control circuit
3 Locking pins (left)
4 Hydraulic cylinder for the implement locking
mechanism
5 Locking pins (right)
11
5
5
4
4
3
3
2
2
B06I