Stoll FS - Aligning for Mounting

63 B58FZS 0000000078 EN 002
START-UP
5.6 Aligning the front loader for mounting
⚠ WARNING
Risk of injury and accident when the front loader is not locked correctly!
When the front loader locking mechanism is not adjusted correctly, the front loader can slip out of the
mounting and cause accidents or personal injury.
 Make sure that the front loader locking mechanism is adjusted correctly.
NOTICE
Material damage due to abrupt operation!
When aligning the front loader, abrupt movements can cause damage to the front loader and the
mountings.
 Before mounting the front loader, check that the operating lever moves smoothly.
 Make sure that the tractor and front loader are operated gently.
If the front loader is being mounted for the first time or if it was previously used with a different tractor,
the front loader pillars can be too high or too low for mounting. In this case, the front loader has to be
aligned for mounting.
Aligning and mounting the front loader:
(1) Release the front loader locking mechanism.
 Push both locking levers up.
(2) Slowly drive the tractor centrally in the lifting arm.
 Drive the tractor forwards until the mountings are as close as possible to the front loader pillars.
(3) Switch off the tractor.
 Apply the parking brake.
 Stop the engine.
 Depressurize the hydraulic system.
(4) Connect the hydraulic lines.
(5) Connect the electric cables.
(6) Start the tractor.
(7) Align the front loader pillars.
 Use the lifting, lowering, dumping and scooping functions until the front loader pillars are at the
right height.
(8) Drive the tractor forwards until the two locking pins touch the slide rails and the catch hooks.
 The front loader is aligned for mounting on the tractor.
(9) Close the front loader locking mechanism.
 Use the lifting function until the front loader is just above the ground.
 Apply the parking brake.
 Stop the engine.
 Shift both locking levers downwards.
(10) Fold in the parking supports.
 Fold in both parking supports (see 6.2 Operating the parking supports).
 The front loader is mounted and ready for operation.