Stoll FS - Activating and Deactivating the Road Operation Lock; Passing through Low Clearances

91 B58FZS 0000000078 EN 002
OPERATION
6.7.1 Activating and deactivating the road operation lock
Tractor's own operating lever
To activate the road operation lock:
(1) Lock the operating lever in the zero position. If it is not possible to lock the operating lever, close
the shut-off valve in the lifting hydraulic line (see tractor operating instructions).
 The road operation lock is activated. Accidental actuation of the front loader is no longer possible.
Tractor-specific operating lever and additional Comfort hydraulic system
To activate the road operation lock:
(1) Move the switch for the Comfort hydraulic system (see 4.9.2 Comfort Drive) to the "Original function
active" switch position.
 The road operation lock is activated. Accidental actuation of the front loader is no longer possible.
STOLL Base Control
To activate the road operation lock:
(1) Lock the operating lever (see 6.1.3 STOLL Base Control) in the zero position.
 The road operation lock is activated. Accidental actuation of the front loader is no longer possible.
STOLL Pro Control
To activate the road operation lock:
(1) Switch the operating lever (see 6.1.4 STOLL Pro Control) to standby mode.
 The road operation lock is activated. Accidental actuation of the front loader is no longer possible.
6.7.2 Passing through low clearances
When passing e.g. bridges, power lines or trees, the clearance height can be too low for the raised front
loader. In this case, the following procedure must be observed:
Passing through low clearances:
(1) Stop before driving through.
(2) Deactivate the road operation lock.
(3) Use the scooping and dumping function to warm up the control unit if necessary.
(4) Lower the front loader.
(5) Pass through the clearance.
(6) Once the clearance has been passed, raise the front loader.
(7) Activate the road operation lock.
 The clearance has been passed.