Stoll FS - Page 39

B58FZS 0000000078 EN 002 38
FUNCTIONS
The mechanical implement locking mechanism
on Euro, SMS and Combi change frames is
actuated manually.
The implement is hinged with its hooks on the top
cross bar on the change frame.
Below, the implement rests on the bottom cross
bar. Both eyelets of the implement project into the
mountings of the change frame.
The locking mechanism is held open by the stop.
When lifting the handle, the locking mechanism is
closed by the spring, as the front loader pin is
pushed through the eyelets of the implement.
When scooping, the handle is lifted by a guide
piece on the lifting arm, and the locking
mechanism closes automatically.
Doe not raise the front load higher than
1.5 m until proper locking of the implement
locking mechanism has been checked!
Fig. 21 Open (top) and closed (bottom) locking
mechanism
Legend
1 Implement
2 Hook
3 Upper cross bar
4 Handle
5Stop
6Eyelet
7Spring
8 Lower cross bar
B06O
11
3
322
6
6
2
2
4
4 77 88
4
4
6
6
7
7
5
5