STONEX R25LR - Cogo

Stonex R25/R25LR Total Station - User Manual 58
8.4. COGO
COGO is an application program able to perform coordinate geometry calculations such as coordinates of points,
bearings between points and distances between points.
Select one of the following COGO calculation methods, pressing the respective keys:
1. Inverse & Traverse:
2. Intersections (Bearing-Bearing, Bearing-Distance, Distance-Distance, Four points)
3. Offset (Distance- Offset, Set Point By...)
4. Extension
The explanation for the softkeys given below are valid for all pages, unless otherwise stated.
Depending on the selected method, it will be required to input the following data:
• Point: it is possible to:
o Measure a new point: press F1[MEASURE] to enter the measure mode;