Stonex R25/R25LR Total Station - User Manual 71
8.8. Reference line/arc
This program facilitates the easy stake out or checking of lines for buildings, sections of road, simple excavations,
etc. Two methods are available: reference line and reference arc.
8.8.1. Reference Line
A reference line can be defined by referencing a known base line. The reference line can be offset either
longitudinally, in parallel or perpendicularly to the base line, or be rotated around the first base point as desired.
Besides the reference height can be selected as first point, second point or interpolated along the reference line.
Press F2[REFLINE] and, as first, it will be required to define the Base line
The base line is determined by two base points that can be defined in
three ways:
• Measured points: Input PtID and measure base points with
F1[ALL] or F2[DIST]+F3[REC];
• Input coordinates manually: Press [ENH] to input;
• Find points from memory: Press [FIND] to search for PtID
entered or press [LIST] to choose from a series of points.
To Next Page
Loading...
