F-40 Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Service Manual • August 2009
Note – Once a volume has been deleted, it cannot be recovered. When a RAID 1
volume is deleted, the data is preserved on the primary disk. The master boot records
(MBR) of other disks in the array are deleted. For other RAID types, the master boot
records of all disks are deleted.
F.4.10 Locating a Disk Drive
There are several ways to physically locate a disk drive, as long as the firmware is
correctly configured and the drives support disk location.
■ During RAID creation, when a disk is set to Yes as part of a RAID volume, its
locate LED is enabled. When it is set back to No or the RAID volume is created,
the locate LED is cleared.
■ Disks can also be located from the SAS Topology screen. To locate a disk, move the
cursor to the disk and press Enter. The Locate LED on the disk remains activate
until the next key is pressed.
To Next Page
Loading...
