3-2 Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Service Manual • August 2009
3.1 Tools and Supplies Needed
The server can be serviced with the following items:
■ No. 2 Phillips screwdriver
■ Adjustable-setting torque driver (5–20 in-lbs)
■ Antistatic wrist strap
■ Nonconducting pointer or stylus, to press the recessed Power button
■ 8-mm nut driver, for motherboard replacement
■ Long-nosed pliers, optional for Graphics Redirect and Service Processor (GRASP)
board removal
3.2 Locations of Replaceable Components
For locations of replaceable Sun Fire X4100/X4100 M2 and Sun Fire X4200/X4200
M2 servers, see “Replaceble Components Overview” on page 1-4.
3.3 Servicetool FRU Update Procedure
Caution – The SunService account is for the use of Sun service representatives only.
Do not use the SunService account unless you are instructed to do so in a procedure
developed by Sun Microsystems.
Note – The servicetool command is supplied on Sun Fire X4100/X4200 servers
that have SP firmware 10708 and later.
1. Use SSH to log into the SunService account. The default password is
changeme.
# ssh <SP IP address> -l sunservice
# <SP IP Address's> password: changeme
To Next Page
Loading...
