Chapter 3 Maintaining the Sun Fire Servers 3-3
2. At the prompt, enter the servicetool command with options. The options are
defined in the following table.
# servicetool --fru_update=mainboard <Other Options>=<value>
3. Watch the output from the command and respond to the confirmation prompts
for continuing the update and rebooting the server.
Servicetool is going to update the mainboard FRU with product and
chassis information collected from the removed mainboard.
The following preconditions must be true for this to work:
* The new mainboard must be installed.
* The service processor must not have been replaced with
the motherboard.
* The service processor firmware must not have been upgraded
prior to the motherboard replacement; do firmware upgrades
after component swaps!
Do you want to continue (y|n)? y
Mainboard FRU configuration has been updated.
You MUST reboot the service processor for to complete this process.
Allow the service processor to fully boot.
DO NOT UNPLUG THE SYSTEM WHILE THE SERVICE PROCESSOR IS BOOTING!
Would you like to reboot the service processor now (y|n)? y
The system is going down NOW!!
Sending SIGTERM to all processes.
Other Options Value
--fru_product_part_number Write a new part number to the FRU.
--fru_product_serial_number Write a new serial number to the FRU.
--fru_chassis_serial_number Write a new chassis serial number to the FRU.
--fru_asset_tag
Write a new asset tag to the FRU.
To Next Page
Loading...
