2-1
CHAPTER
2
Powering On and Configuring BIOS
Settings
This chapter contains the following procedures and information:
■ Section 2.1, “Powering On the Server” on page 2-2
■ Section 2.2, “Powering Off the Server” on page 2-3
■ Section 2.3, “Configuring BIOS Settings” on page 2-4
■ Section 2.4, “Resetting SP and BIOS Passwords Using Jumper P4 or J12” on
page 2-53
■ Section 2.5, “Using the Force-Recovery Jumper P5 or J13” on page 2-57
■ Section 2.6, “Using the Clear CMOS Jumper TP51/TP52 or J9” on page 2-59
■ Section 2.7, “Using the Reset and NMI Switches” on page 2-60
■ Section 2.8, “Updating the BIOS” on page 2-61
■ Section 2.9, “Power-On Self-Test (POST)” on page 2-61
Note – The information in this chapter applies to all Sun Fire X4100/X4100 M2 and
X4200/X4200 M2 servers, unless otherwise noted.
To Next Page
Loading...
