vi Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Service Manual • August 2009
3.4 Powering Off the Server 3–4
3.5 Removing the Main Cover of the Sun Fire X4100/X4100 M2 Server 3–6
3.6 Removing the Front Bezel of the Sun Fire X4100/X4100 M2 Server 3–7
3.7 Removing the Front Cover of the Sun Fire X4100/X4100 M2 Server 3–8
3.8 Removing the Main Cover of the Sun Fire X4200/X4200 M2 Servers 3–10
3.9 Removing the Front Bezel of the Sun Fire X4200/X4200 M2 Servers 3–11
3.10 Removing the Front Cover of the Sun Fire X4200/X4200 M2 Servers 3–12
3.11 HT Jumper Configuration for Single-CPU Servers (Sun Fire X4100 M2 and
X4200 M2) 3–13
3.12 Replaceable Component Procedures 3–14
3.12.1 Replacing the Battery 3–15
3.12.2 Replacing a CPU and Heatsink (Sun Fire X4100 and X4200 Servers)
3–17
3.12.3 Replacing a CPU and Heatsink (Sun Fire X4100 M2/X4200 M2
Servers) 3–23
3.12.4 Replacing the DVD-ROM Drive 3–30
3.12.5 Installing a DVD-ROM Drive Upgrade Kit 3–33
3.12.6 Replacing a Fan Module 3–38
3.12.7 Replacing a Fan Connector Board 3–41
3.12.8 Replacing the Front Panel Indicator Board 3–44
3.12.9 Replacing the Front I/O Board 3–46
3.12.10 Replacing the Graphics Redirect and Service Processor (GRASP)
Board 3–51
3.12.11 Servicetool FRU Update Procedure 3–53
3.12.12 Replacing a Drive 3–54
3.12.13 Replacing the Drives Backplane 3–57
3.12.14 DIMM Population Rules 3–61
3.12.14.1 Supported DIMM Configurations 3–63
3.12.14.2 Installing DIMMs Into a Single-CPU System 3–64
3.12.15 Replacing DIMMs 3–65
To Next Page
Loading...
